Dell GX1 User Manual download pdf (Page 105)

Installing System Board Options 6-9

 , QVWDOORU UHSODFH', 00VDVQHFHVVDU\WRUHDFKWKHGHVLUHGPHPRU\

WRWDO

Follow the instructions in “Installing a DIMM” or Removing a DIMM,” as appro-

priate, found later in this section.

  5RWDWHWKHSRZHUVXSSO\EDFNLQWRWKHFRPSXWHUFKDVVLV

 5HSODFHWKHFRPSXW HUFRYHUUHFRQQHFW\RXUFRP SXWHUDQ GSHULSKHUDOV

WRWKHLUSRZHUVRXUFHVDQGWXUQWKHPR Q

NOTE: After you remove and replace the cover, the chassis intrusion detector will

cause the following message to be displayed at the next system start-up:

ALERT! Cover was previously removed.

After the system completes the power-on self-test (POST) routine, the system

runs a memory test that displays the total memory of all installed DIMMs, includ-

ing those you just installed.

NOTE: If the memory total is incorrect, turn off your computer and peripherals

and disconnect them from their power sources, remove the computer cover, and

make sure that the installed DIMMs are seated properly in their sockets. Then

repeat this step.

The system detects that the new memory does not match the existing system

configuration information, which is stored in nonvolatile random-access memory

(NVRAM), and generates the following message:

The amount of system memory has changed.

Strike the F1 key to continue, F2 to run the setup utility

  3UHVV ) !WRHQWHUWKH6\VWHP6HWXS SURJUDPFKHFNWKH6\VWHP

0HPRU\FDWHJRU\LQWKHORZHUULJKWFRUQHURI 3DJHDQGUHVHW&KDVVLV

,QWUXVLRQWR1RW'HWHFWHG

The system should have already changed the value in the System Memory cate-

gory to reflect the newly installed memory. Verify the new total.

NOTES: If the memory total is incorrect, turn off your computer and peripherals

and disconnect them from their power sources, remove the computer cover, and

check the installed DIMMs to make sure that they are seated properly in their

sockets. Then repeat steps 6 and 7.

The value of System Memory is given in kilobytes (KB). To convert KBs to MBs,

divide the KB total by 1024.

 : KHQWKH6\VWHP0 HPRU\W RWDOLVFRUUHFWSUHVVWKH(VF!NH\WRH[LW

W KH6\VWHP6HWXSSURJUDP

 5 XQWKH'HOO'LDJQRVWLFVWRYHULI\WKDWWKH',00VDUHRSHUDW LQJ

SURSHUO\

See your

Diagnostics and Troubleshooting Guide

for information on running the

Dell Diagnostics and troubleshooting any problems that may occur.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 173 174

No comments

Dell GX1 User Manual Page 105