Dell GX1 User Manual Page 134

  • Download
  • Add to my manuals
  • Print
  • Page
    / 174
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 133
7-20 Dell OptiPlex GX1 and GX1p Mini Tower Managed PC Systems Reference and Installation Guide
5HSODF HWKH FRPSX WHUFRYHU7KHQUHF RQQHF W \RXUFR PSXWHUDQGSHULSK
HUDOVWRWKHLUSRZHUVRXUFHVDQGWXUQWKHPRQ
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
 7RUHVHWWKHFKDVVLVLQWUXVLRQGHWHFWRU HQWHUWKH6\VWHP6HWXSSURJUDP
DQGUHVHW&KDVVLV, QWUXVLRQWR1 RW'HWHFWHG,IQHFHVVDU\XSGDW HWKH
V\VW HPFRQILJXUDWLRQLQIRUPDWLRQIRUWKH'ULYHV3ULPDU\F DWHJRU\
NOTE: If a setup password has been assigned by someone else, contact your
network administrator for information on resetting the chassis intrusion detector.
If you installed a SCSI hard-disk drive, set the Drive category (0 or 1) under
Drives: Primary to None. See Chapter 2, “Using the System Setup Program,” for
instructions.
Tape drives attached to a SCSI host adapter card are not part of the system con-
figuration information.
 , I\RXLQVWDOOHGD6&6,KDUGGLVNGULYHSDUWLWLRQDQGIRUPDWWKHGULYH
7KHQLQVWDOOWKHRSHUDWLQJV\VWHP
For instructions, see the next subsection, “Partitioning and Formatting SCSI
Hard-Disk Drives,” and your operating system documentation.
 7HVWWK H6&6,GHYLFHV
Test a SCSI hard-disk drive by running the SCSI Device(s) test group of the Dell
Diagnostics. See your
Diagnostics and Troubleshooting Guide
for information on
running the Dell Diagnostics and troubleshooting any problems that may occur.
To test a SCSI tape drive, refer to the documentation for the tape drive software
to perform a tape drive backup and verification test.
3DUWLWLRQLQJDQG)RUP DWWLQJ6&6,+DUG'LVN'ULYHV

You may need to use different programs than those provided with the operating sys-
tem to partition and format SCSI hard-disk drives. Refer to the documentation that
came with your SCSI software drivers for information on installing the appropriate
drivers and preparing your SCSI hard-disk drive for use.
NOTE: On systems with hard-disk drives larger than 2 GB, create a primary partition
of 2 GB and divide the remaining capacity into partitions of 2 GB or less. For example,
a system with a 2.5-GB hard-disk drive would have a primary partition of 2 GB (drive
C) and a second partition of 500 MB (drive D). Hard-disk drives must be partitioned
this way because MS-DOS–based operating systems (including Windows NT, when
using a FAT16 file system) do not support drive partitions larger than 2 GB.
Page view 133
1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 173 174

Comments to this Manuals

No comments