Dell GX1 User Manual download pdf (Page 146)

B-6 Dell OptiPlex GX1 and GX1p Mini Tower Managed PC Systems Reference and Installation Guide

&RQILJXUDWLRQ0 DQDJHU0HVVDJHV

The Configuration Manager for the ICU identifies problems following system boot and

generates messages if necessary. These messages alert you to any unsuccessful

attempts to configure Plug and Play or Peripheral Component Interconnect (PCI)

expansion cards, as well as any problems that interfere with the operation of the Con-

figuration Manager. If you receive a message from the Configuration Manager, see

Table B-2 for suggestions on resolving any problems indicated by the message.

7DEOH%&RQILJXUDWLRQ0DQDJHU0HVVDJHV  

0HVVDJH 3U REDEOH&DXVH &RUUHFWLYH$FWLRQ

Found Plug and Play ISA

card:

Plug and Play ISA

Card Name

This message appears at

system start-up for each

Plug and Play ISA expan-

sion card recognized by

the Configuration

Manager.

Status message; no action is required.

NOTICE: Boot Device Not

Active! CSN=

Card Select

Number

A boot device was found

to be inactive.

Status message; no action is required. The

Configuration Manager automatically con-

figures and activates the device.

One or more active

devices have been re

configured -- system

requires reboot. Press

any key to reboot system.

You modified the

resource values of one or

more PCI or Plug and

Play ISA expansion cards.

Reboot the system to reconfigure the

card(s).

The Plug and Play ISA

card has been success-

fully configured.

Card Count Plug and Play

ISA cards have been suc-

cessfully configured.

The Configuration Man-

ager has successfully

configured the given

number of cards.

If this message does not match the num-

ber of Plug and Play ISA expansion cards

installed in your computer, reinstall any

Plug and Play expansion cards not listed

and reboot the system.

ERROR: Insufficient CM

Memory

There is not enough

memory available to the

Configuration Manager

for it to run.

Disable any TSR programs or any

unneeded device drivers.

ERROR: Fatal BIOS error

Internal Error Code.

A BIOS call failed with an

internal error. The most

likely cause is an incom-

patibility between the

BIOS and the Configura-

tion Manager.

See Chapter 7, “Getting Help,” in your

Diagnostics and Troubleshooting Guide

for

instructions on obtaining technical

assistance.

ERROR: Could not read

NVS, Error=

Internal

Error Code

An attempt to read the

NVRAM failed.

See Chapter 7, “Getting Help,” in your

Diagnostics and Troubleshooting Guide

for

instructions.

NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online

System User’s Guide

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 173 174

Comments to this Manuals

No comments

Dell GX1 User Manual Page 146

Comments to this Manuals

Related products and manuals for Graphics cards Dell GX1