Dell PowerConnect 8100 Series User Manual download pdf (Page 13)

13 SCG1001 PowerConnect 8100 Series Configuration Guide

console(config-if-dcb)#exit

console(config-if)#exit

4.2 Revert to default VLAN ID on switch and arrays

Once DCB is disabled on the switch, the EqualLogic arrays will no longer use the VLAN ID that was

configured when DCB was enabled. The arrays will revert to the default or native VLAN. Therefore, a valid

VLAN must be configured for all host servers, switches, and EqualLogic array members. A valid VLAN can

use the default or native VLAN ID (typically 0 or 1) or a specific VLAN can be configured (for example,

VLAN 100). If a non-default VLAN is configured, then any ports connected to the arrays must be

configured as “untagged”.

Use the steps below to configure the native VLAN on the switch.

console#configure

console(config)#interface range tengigabitethernet all

console(config-if)#no switchport mode

console(conf-if)#exit

console(config)#interface range fortygigabitethernet all

console(config-if)#no switchport mode

console(config-if)#exit

console(config)#interface port-channel 1

console(config-if)#no switchport mode

console(config-if)#exit

console(config)#no vlan vlan-id

console(config)#exit

4.3 Save configuration

console# copy running-config startup-config

This operation may take a few minutes.

Management interfaces will not be available during this time.

Are you sure you want to save? (y/n)y

1 2 ... 8 9 10 11 12 13 14 15 16

No comments

Dell PowerConnect 8100 Series User Manual Page 13