202 | DHCP Configuration DellNetworking W-Series Instant 6.4.0.2-4.1 | User Guide
Figure 62 New DHCP Scope: Distributed DHCP Mode
3. Based on the type of distributed DHCP scope, configure the following parameters:
Name Description
Name
Enter a name for the DHCP scope.
Type
Select any of the following options:
l Distributed, L2— On selecting Distributed, L2, the Virtual Controller acts as the
DHCP Server but the default gateway is in the data center. Traffic is bridged into
VPN tunnel.
l Distributed, L3— On selecting Distributed, L3, the Virtual Controller acts as both
DHCP Server and default gateway. Traffic is routed into the VPN tunnel.
VLAN Specify a VLANID. To use this subnet, ensure that the VLANID specified here is
assigned to an SSID profile. For more information on SSID profile configuration, see
Configuring VLAN Settings for a WLAN SSID Profile on page 97 and Configuring
VLAN for a Wired Profile on page 114
Netmask If Distributed, L2 is selected for type of DHCP scope, specify the subnet mask. The
subnet mask and the network determine the size of subnet.
Default router If Distributed, L2 is selected for type of DHCP scope, specify the IP address of the
default router.
DNS Server If required, specify the IP address of a DNS server.
Domain Name If required, specify the domain name.
Table 38:
Distributed DHCP Mode: Configuration Parameters
Comments to this Manuals