Dell PowerConnect W-IAP3WN/P User Manual Page 91

  • Download
  • Add to my manuals
  • Print
  • Page
    / 377
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 90
91 | Customizing W-IAP Settings Dell Networking W-Series Instant 6.4.0.2-4.1 | User Guide
Iap_master:1
Adding a W-IAP to the Network
To add a W-IAP to the Instant network, assign an IP address. For more information, see Assigning an IP address to
the W-IAP on page 35.
After a W-IAP is connected to the network, if the Auto Join Mode feature is enabled, the W-IAP inherits the
configuration from the Virtual Controller and is listed in the Access Points tab.
If the Auto Join Mode is disabled, perform the following steps to add a W-IAP to the network:
1. In the Access Points tab, click the New link. The New Access Point window is displayed.
2. In the New Access Point window, enter the MAC address for the new W-IAP.
3. Click OK.
Removing a W-IAP from the Network
You can remove a W-IAP from the network only if the Auto Join Mode feature is disabled. To remove a W-IAP from
the network:
1. In the Access Points tab, click the W-IAP to delete. The x icon is displayed against the W-IAP.
2. Click x to confirm the deletion.
The deleted W-IAPs cannot join the Instant network anymore and no longer are displayed in the Instant UI.
However, the master W-IAP details cannot be deleted from the Virtual Controller database.
Page view 90
1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 376 377

Comments to this Manuals

No comments