Dell T110 II Owner's Manual Page 21
- Page / 142
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
About Your System 21
Caution!
NVRAM_CLR jumper
is installed on
system
board.Please run
SETUP.
NVRAM_CLR jumper is
installed in the clear
setting. CMOS has been
cleared.
Move the NVRAM_CLR
jumper to the default position
(pins 3 and 5). See Figure 6-1
for jumper location. Restart
the system and re-enter the
BIOS settings. See "Using the
System Setup Program and
UEFI Boot Manager" on
page 35.
CPU set to
minimum
frequency.
The processor speed may
be intentionally set lower
for power conservation.
If not an intentional setting,
check other system messages
for possible causes.
Current boot mode
is set to UEFI.
Please ensure
compatible
bootable media is
available. Use
the system setup
program to change
the boot mode as
needed.
The system failed to boot
because UEFI boot mode is
enabled in BIOS and the
boot operating system is
non-UEFI.
Ensure that the boot mode is
set correctly and that the
proper bootable media is
available. See "Using the
System Setup Program and
UEFI Boot Manager" on
page 35.
Decreasing
available
memory.
Faulty or improperly
installed memory modules.
Reseat the memory modules.
See "Troubleshooting System
Memory" on page 119.
Embedded NICx and
NICy:
OS NIC=<ENABLED
|DISABLED>,
Management
Shared NIC=
<ENABLED
|DISABLED>
The operating system NIC
interface is set in BIOS.
The Management Shared
NIC interface is set in
management tools.
Check the system
management software or the
System Setup program for
NIC settings. If a problem is
indicated, see
"Troubleshooting a NIC" on
page 113.
Message Causes Corrective Actions
Coaster_HOM.book Page 21 Monday, November 3, 2014 3:23 PM
- Owner’s Manual 1
- Notes, Cautions, and Warnings 2
- Contents 3
- 4 Contents 4
- 6 Contents 6
- 8 Contents 8
- Contents 9 9
- 10 Contents 10
- About Your System 11
- 12 About Your System 12
- 14 About Your System 14
- NIC Indicator Codes 16
- Diagnostic Lights 17
- 18 About Your System 18
- System Messages 19
- 20 About Your System 20
- 22 About Your System 22
- 24 About Your System 24
- MEMTEST lane 24
- 26 About Your System 26
- 30 About Your System 30
- Glossary 31
- Warning Messages 32
- Diagnostics Messages 32
- Alert Messages 32
- About Your System 33 33
- 34 About Your System 34
- Choosing the System Boot Mode 35
- Responding to Error Messages 36
- System Setup Options 37
- Memory Settings Screen 39
- Processor Settings Screen 39
- SATA Settings Screen 40
- Boot Settings Screen 41
- Integrated Devices Screen 41
- PCI IRQ Assignments Screen 42
- Serial Communication Screen 43
- Power Management Screen 44
- System Security Screen 45
- Exit Screen 47
- UEFI Boot Manager Screen 48
- UEFI Boot Settings Screen 48
- System Utilities Screen 49
- Using the System Password 49
- Using the Setup Password 52
- Embedded System Management 53
- Entering the BMC Setup Module 54
- Inside the System 58
- Opening the System 59
- Closing the System 60
- Front Bezel 61
- Installing the Front Bezel 62
- Removing Front Bezel Insert 62
- EMI Filler Panel 63
- 1 shoulder screws (3)* 69
- Hard Drives 70
- Expansion-Card Stabilizer 78
- Cooling Shroud 78
- Removing the Cooling Shroud 79
- Installing the Cooling Shroud 80
- Expansion Cards 81
- Removing an Expansion Card 82
- Installing an Expansion Card 84
- SAS Controller Expansion Card 85
- System Memory 86
- Removing Memory Modules 88
- Installing Memory Modules 89
- Processor 91
- Installing a Processor 94
- Cooling Fan 95
- Installing the Cooling Fan 96
- System Battery 97
- Power Supply 99
- Installing the Power Supply 100
- Internal USB Memory Key 101
- Chassis Intrusion Switch 102
- Control Panel Assembly 104
- System Board 107
- Installing the System Board 109
- Installing System Components 110
- Troubleshooting Your System 111
- Troubleshooting a USB Device 112
- Troubleshooting a NIC 113
- Troubleshooting a Wet System 114
- Troubleshooting Power Supply 117
- Troubleshooting Cooling Fan 118
- Troubleshooting System Memory 119
- Troubleshooting a Hard Drive 123
- Troubleshooting the Processor 125
- Using Online Diagnostics 127
- Using the Custom Test Options 129
- Jumpers and Connectors 131
- System Board Connectors 132
- Getting Help 135
- 136 Getting Help 136
- Numerics 137
- Index 139 139
- Index 141 141
- 142 Index 142
Related products and manuals for Servers Dell T110 II
Servers Dell R210 II Specifications
(67 pages)
(67 pages)
Servers Dell T420 Manual
(27 pages)
(27 pages)
Servers Dell PowerEdge T110 II Owner's Manual
(130 pages)
(130 pages)
Servers Dell T420 Specifications
(53 pages)
(53 pages)
Servers Dell R930 Owner's Manual
(177 pages)
(177 pages)
Servers Dell R220 Specifications
(48 pages)
(48 pages)
Servers Dell R520 Specifications
(51 pages)
(51 pages)
Servers Dell T420 Specifications
(52 pages)
(52 pages)
Servers Dell R520 Owner's Manual
(141 pages)
(141 pages)
Servers Dell R210 II Specifications
(57 pages)
(57 pages)
Servers Dell T20 Specifications
(29 pages)
(29 pages)
Servers Dell R720 Specifications
(65 pages)
(65 pages)
Servers Dell T20 Specifications
(30 pages)
(30 pages)
Servers Dell R210 II Owner's Manual
(144 pages)
(144 pages)
Servers Dell PowerEdge R610 Specifications
(56 pages)
(56 pages)
Servers Dell R530 Owner's Manual
(154 pages)
(154 pages)
Servers Dell R320 Specifications
(51 pages)
(51 pages)
Servers Dell R420 Owner's Manual
(145 pages)
(145 pages)
Servers Dell R320 Specifications
(50 pages)
(50 pages)
Servers Dell PowerEdge R410 Specifications
(58 pages)
(58 pages)
© 2020, manymanuals.com. All rights reserved. | 1.057 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals