Dell OptiPlex GX200 Service Manual download pdf (Page 15)

3. Insert the expansion card into the expansion-card connector.

If the expansion card is full-length, insert the front end of the card into the corresponding card guide on the inside front of the chassis as you

insert the card into its connector. Insert the card's edge connector firmly into the expansion-card slot.

4. When the card is firmly seated in the connector, secure the card's mounting bracket to the chassis with the screw you removed in step 2.

5. Connect any cables that should be attached to the card.

See the documentation for the card for information about the card's cable connections.

6. Replace the computer cover and reset the chassis intrusion detector.

Memory

To remove a Rambus in-line memory module (RIMM), perform the following steps:

1. Remove the computer cover.

2. Remove the system power supply to allow you to access the RIMMs.

3. Press the securing clips outward simultaneously until the RIMM disengages and pops out slightly from the socket (see Figure 22).

Figure 22. Removing a RIMM

To reinstall a RIMM, perform the following steps:

1. Locate the plastic securing clips at each end of the socket (see Figure 23).

2. Press the clips outward until they snap open.

3. Press the RIMM straight into the slot running down the center of the socket until the securing tabs snap into place around the ends of the

RIMM.

4. Replace the computer cover and reset the chassis intrusion detector.

Figure 23. Installing a RIMM

Filler bracket

Securing clips (2)

1 ... 14 15 16 ... 79

No comments

Dell OptiPlex GX200 Service Manual Page 15