Dell OptiPlex GX200 Service Manual download pdf (Page 76)

To reinstall a RIMM, perform the following steps:

1. Locate the plastic securing clips at each end of the socket (see Figure 26).

2. Press the clips outward until they snap open.

3. Press the RIMM straight into the slot running down the center of the socket until the securing tabs snap into place around the ends of the

RIMM.

4. Replace the computer cover.

5. Reset the chassis intrusion detector.

Figure 26. RIMM Installation

6. Run the Dell Diagnostics to verify that the RIMMs are operating properly.

Microprocessor/Cooling Fan/Heat Sink Assembly

Figure 27. Microprocessor/Cooling Fan/Heat Sink Assembly

To replace a microprocessor, perform the following steps:

Securing clips (2)

Notches (2)

Cooling fan/heat sink assembly

ZIF socket

Retaining clip

CAUTION: The microprocessor/heat sink assembly can get extremely hot. Be sure that the assembly has had sufficient time to

cool before you touch it.

NOTE: Dell recommends that only a technically knowledgeable person perform this procedure.

1 ... 75 76 77 78 79

No comments

Dell OptiPlex GX200 Service Manual Page 76