
No. n/Address (n is 1 to 5.)
Sets the IP address for Filter n.
No. n/Mask (n is 1 to 5.)
Sets the mask for Filter n.
No. n/Mode (n is 1 to 5.)
Disable the IP Filter feature for Filter n.
Accepts an access from specified IP address.
Rejects an access from specified IP address.
*
1
This item is only available for LPD or Port9100.
Reset LAN
Purpose:
To initialize wired network data stored in NV (non-volatile) memory. After executing this function and
rebooting the printer, all wired network settings are reset to their default values.
Adobe Protocol
Purpose:
To specify PostScript communication protocol for each interface. You can configure the Adobe Protocol
settings for the wired network. The change becomes effective after the printer is turned off and then on
again.
Values:
Used when auto-detecting the PostScript communication protocol.
Used when the communication protocol is in ASCII interface.
Used when the communication protocol is in binary format.
Used when the communication protocol supports both ASCII and binary data to switch between
them according to the specified control code.
Used when no special processing is required for data.
Comments to this Manuals