
Automatically sets the frame type.
Uses the Ethernet II frame type.
Uses the IEEE802.3 frame type.
Uses the IEEE802.2 frame type.
IP Filter (IPv4)
Purpose:
To specify that data received from certain IP addresses through the wireless network is blocked. You can set
up to 5 IP addresses. The change becomes effective after the printer is turned off and then on again.
Values:
No. n/Address (n is 1 to 5.)
Sets the IP address for Filter n.
No. n/Mask (n is 1 to 5.)
Sets the mask for Filter n.
No. n/Mode (n is 1 to 5.)
Disable the IP Filter feature for Filter n.
Accepts an access from specified IP address.
Rejects an access from specified IP address.
*
1
This item is only available for LPD or Port9100.
Reset MPC
Purpose:
To initialize wireless network data stored in NVRAM.
Adobe Protocol
Comments to this Manuals