Table 5-1.SystemBoardJumperSettings
System Board Connectors
See Figure5-3 and Table5-2 for the descriptions and locations of the system board connectors.
Figure 5-3. System Board Connectors and Sockets
Table 5-2.SystemBoardConnectorsandSockets
Reserved (do not change).
The password feature is enabled.
The password feature is disabled.
The configuration settings are retained at system boot.
The configuration settings are cleared at next system boot. (If the configuration settings become corrupted to the point
where the system will not boot, install the jumper plug and boot the system. Remove the jumper before restoring the
configuration information.)
SCSI backplane board connector
Cable-management arm system status connector
Connector for optional RAC
RAC Ethernet port connector
NIC connectors (2)
NOTE: If you purchased a 400-MHz front-side bus system with a preinstalled Gigabit PCI network card, the integrated NIC
connectors are nonfunctional.
Cooling fan power connectors (six on system board; one on control panel assembly)
System control panel connector
PCI riser board connector
Comments to this Manuals