Dell R210 II Owner's Manual Page 41
- Page / 144
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Using the System Setup Program and UEFI Boot Manager 43
Boot Settings Screen
Port C
(Off default)
Auto enables BIOS support for the device attached to
SATA port C. Off disables BIOS support for the device.
eSATA port
(Off default)
Auto enables BIOS support for the device attached to the
eSATA port. Off disables BIOS support for the device.
Option Description
Boot Mode
(BIOS default)
CAUTION: Switching the boot mode could prevent
the system from booting if the operating system was
not installed in the same boot mode.
If the operating system supports Unified Extensible
Firmware Interface, you can set this option to UEFI.
Setting this field to BIOS allows compatibility with non-
UEFI operating systems.
NOTE: Setting this field to UEFI disables the Boot
Sequence, Hard-Disk Drive Sequence, and USB Flash Drive
Emulation Type fields.
Boot Sequence If Boot Mode is set to BIOS, this field tells the system
where the operating system files needed for startup are
located. If Boot Mode is set to UEFI, you can access the
UEFI boot manager utility by rebooting the system and
pressing <F11> when prompted to do so.
Hard-Disk Drive
Sequence
Determines the order in which the BIOS will attempt to
boot from hard drives in the system during
system startup.
USB Flash Drive
Emulation Type
(Auto default)
Determines the emulation type for a USB flash drive.
Hard disk allows the USB flash drive to act as a hard
drive. Floppy allows the USB flash drive to act as a
removable diskette drive.
Auto automatically chooses the appropriate emulation
type for the device. If you install a device in this slot that
is configured as a removable diskette drive, you must
manually set the emulation type to Floppy.
Boot Sequence Retry
(Disabled default)
If this field is enabled and the system has failed to boot,
the system will reattempt to boot after 30 seconds.
Option Description
book.book Page 43 Wednesday, August 12, 2009 4:51 PM
- Hardware Owner’s 1
- Notes, Cautions, and Warnings 2
- Contents 3
- 6 Contents 4
- 8 Contents 6
- 10 Contents 8
- Contents 11 9
- 12 Contents 10
- About Your System 11
- 14 About Your System 12
- 16 About Your System 14
- NIC Indicator Codes 16
- Diagnostic Lights 17
- 20 About Your System 18
- System Messages 19
- 22 About Your System 20
- 24 About Your System 22
- 26 About Your System 24
- MEMTEST lane 24
- 28 About Your System 26
- 32 About Your System 30
- Warning Messages 32
- Diagnostics Messages 32
- Alert Messages 32
- 36 About Your System 34
- Choosing the System Boot Mode 35
- Responding to Error Messages 36
- System Setup Options 37
- Memory Settings Screen 39
- Processor Settings Screen 39
- SATA Settings Screen 40
- Boot Settings Screen 41
- Integrated Devices Screen 42
- PCI IRQ Assignments Screen 43
- Serial Communication Screen 43
- Power Management Screen 44
- System Security Screen 45
- Exit Screen 47
- UEFI Boot Manager Screen 48
- UEFI Boot Settings Screen 48
- System Utilities Screen 49
- Using the System Password 49
- Using the Setup Password 52
- Embedded System Management 53
- Entering the BMC Setup Module 54
- Inside the System 58
- Front Bezel (Optional) 59
- Opening the System 60
- Closing the System 61
- Optical Drive (Optional) 62
- Installing an Optical Drive 64
- Hard Drives 65
- Installing a Hard Drive 67
- Expansion Card 70
- Removing an Expansion Card 71
- Expansion-Card Riser 72
- Internal USB Memory Key 74
- Cooling Shroud 75
- System Memory 77
- Mode-Specific Guidelines 78
- Installing Memory Modules 79
- Removing Memory Modules 81
- Cooling Fans 82
- Installing a Cooling Fan 83
- VFlash Media (Optional) 90
- Processor 90
- Installing a Processor 94
- Power Supply 95
- System Battery 97
- Control Panel Assembly 99
- System Board 101
- Installing System Components 102
- Installing the System Board 103
- Figure 6-1 104
- Troubleshooting Your System 105
- Troubleshooting a USB Device 106
- Troubleshooting a NIC 107
- Troubleshooting a Wet System 108
- Troubleshooting Power Supply 111
- Troubleshooting a Fan 112
- Troubleshooting System Memory 112
- Troubleshooting a Hard Drive 116
- Troubleshooting the Processor 118
- Using Online Diagnostics 119
- Using the Custom Test Options 121
- Jumpers and Connectors 123
- System Board Connectors 124
- Getting Help 127
- 134 Getting Help 128
- Glossary 129
- 136 Glossary 130
- 138 Glossary 132
- 140 Glossary 134
- 142 Glossary 136
- 144 Glossary 138
- Index 145 139
- Index 146 140
- Index 147 141
- Index 148 142
- Index 149 143
- Index 150 144
Related products and manuals for Servers Dell R210 II
Servers Dell PowerEdge R610 Specifications
(56 pages)
(56 pages)
Servers Dell R530 Owner's Manual
(154 pages)
(154 pages)
Servers Dell R320 Specifications
(51 pages)
(51 pages)
Servers Dell R420 Owner's Manual
(145 pages)
(145 pages)
Servers Dell R320 Specifications
(50 pages)
(50 pages)
Servers Dell PowerEdge R410 Specifications
(58 pages)
(58 pages)
Servers Dell PowerEdge T310 Specifications
(73 pages)
(73 pages)
Servers Dell R320 Owner's Manual
(143 pages)
(143 pages)
Servers Dell PowerEdge R310 Specifications
(49 pages)
(49 pages)
Servers Dell PS6000X User's Guide
(62 pages)
(62 pages)
Servers Dell PowerEdge M610 Specifications
(30 pages)
(30 pages)
Servers Dell PS4100 Installation Guide
(47 pages)
(47 pages)
Servers Dell DAE2P Setup Guide
(27 pages)
(27 pages)
Servers Dell PowerVault DL2100 User Manual
(18 pages)
(18 pages)
Servers Dell PowerVault NX300 Owner's Manual
(192 pages)
(192 pages)
Servers Dell H730P User Manual
(13 pages)
(13 pages)
Servers Dell H730P User Manual
(35 pages)
(35 pages)
Servers Dell POWEREDGE DL385 User Manual
(23 pages)
(23 pages)
© 2020, manymanuals.com. All rights reserved. | 1.075 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals