Dell R210 II Owner's Manual Page 81

  • Download
  • Add to my manuals
  • Print
  • Page
    / 144
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 80
Installing System Components 83
The system should have already changed the value to reflect the newly
installed memory.
13
If the value is incorrect, one or more of the memory modules may not be
installed properly. Repeat step 2 through step 12 of this procedure, checking to
ensure that the memory modules are firmly seated in their sockets.
14
Run the system memory test in the system diagnostics. See "Running the
Embedded System Diagnostics" on page 126.
Removing Memory Modules
WARNING: The memory modules are hot to touch for some time after the system has
been powered down. Allow time for the memory modules to cool before handling
them. Handle the memory modules by the card edges and avoid touching the
components on the memory module.
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your product
documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty.
Read and follow the safety instructions that came with the product.
CAUTION: To ensure proper system cooling, memory-module blanks must be installed
in any memory socket that is not occupied. Remove memory-module blanks only if you
intend to install memory in those sockets.
1
Turn off the system, including any attached peripherals, and disconnect the
system from the electrical outlet.
2
Open the system. See "Opening the System" on page 62.
3
Remove the
cooling
shroud. See "Removing the Cooling Shroud" on page 77.
4
Locate the memory module sockets. See
Figure 6-1
.
5
Press down and out on the ejectors on each end of the socket until the memory
module pops out of the socket. See Figure 3-11.
Handle each memory module only on either card edge, making sure not to
touch the middle of the memory module.
6
Replace the
cooling
shroud. See "Installing the Cooling Shroud" on page 79.
7
Close the system. See "Closing the System" on page 63.
8
Reconnect the system and peripherals to their power sources, and turn them
on.
book.book Page 83 Wednesday, August 12, 2009 4:51 PM
Page view 80
1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 143 144

Comments to this Manuals

No comments