Dell PowerEdge R905 Owner's Manual download pdf (Page 88)

88 Installing System Components

When the system boots, the

Remote Access Controller

Detected

message displays and the option ROM and firmware

information for the RAC displays.

Press <Ctrl><e> to enter the RAC configuration screen. See the RAC

documentation for information on configuring and using the RAC.

Internal USB Memory Key (Optional)

Your system provides an internal USB connector located on the system board

for use with an optional USB flash memory key (see Figure 6-1). The USB

memory key can be used as a boot device, security key, or mass storage device.

To use the internal USB connector, the Internal USB Port option must be

enabled in the Integrated Devices screen of the System Setup program.

To boot from the USB memory key, you must configure the USB memory key

with a boot image and then specify the USB memory key in the boot

sequence in the System Setup program. See "Using the System Setup

Program" on page 45. For information on creating a bootable file on the USB

memory key, see the user documentation that accompanied the USB memory

key.

Installing the Optional Internal USB Memory Key

CAUTION: Many repairs may only be done by a certified service technician. You

should only perform troubleshooting and simple repairs as authorized in your

product documentation, or as directed by the online or telephone service and

support team. Damage due to servicing that is not authorized by Dell is not covered

by your warranty. Read and follow the safety instructions that came with the

product.

Turn off the system, including any attached peripherals, and disconnect

the system from its electrical outlet.

Open the system. See "Opening the System" on page 67.

Locate the USB connector on the system board (see Figure 6-1).

Insert the USB memory key into the USB connector onto the board. See

Figure 3-15.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 201 202

No comments

Dell PowerEdge R905 Owner's Manual Page 88