Dell PowerEdge R900 User Manual Page 134

  • Download
  • Add to my manuals
  • Print
  • Page
    / 190
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 133
134 Troubleshooting Your System
Use another connector on the switch or hub.
If you are using a NIC card instead of an integrated NIC, see the
documentation for the NIC card.
3
Ensure that the appropriate drivers are installed and the protocols are
bound. See the NIC's documentation.
4
Enter the System Setup program and confirm that the NICs are enabled.
See "Using the System Setup Program" on page 41.
5
Ensure that the NICs, hubs, and switches on the network are all set to the
same data transmission speed. See the network equipment
documentation.
6
Ensure that all network cables are of the proper type and do not exceed the
maximum length. See Network Cable Requirements in your
Getting
Started Guide
.
Troubleshooting a Wet System
Problem
Liquid spilled on the system.
Excessive humidity.
Action
CAUTION: Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before performing any
procedure, see your Product Information Guide for complete information about
safety precautions, working inside the computer and protecting against
electrostatic discharge.
1
Remove power from the system and attached peripherals, and disconnect
the system from the electrical outlet.
2
Open the system. See "Removing the Top Cover" on page 60.
3
Remove all expansion cards installed in the system. See "PCI Express Add-
in Cards" on page 86.
4
Let the system dry thoroughly for at least 24 hours.
5
Reinstall all expansion cards installed in the system. See "PCI Express
Add-in Cards" on page 86.
Page view 133
1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 189 190

Comments to this Manuals

No comments