Dell POWEREDGE R610 User Manual Page 101

  • Download
  • Add to my manuals
  • Print
  • Page
    / 184
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 100
Installing System Components 101
Installing a VFlash Media Card
1
Locate the VFlash media slot at the back corner of the system. See "Back-
Panel Features and Indicators" for the location of the media slot.
2
With the label side facing up, insert the contact-pin end of the SD card
into the card slot on the module.
NOTE: The slot is keyed to ensure correct insertion of the card.
3
Press inward on the card to lock it into the slot.
Removing a VFlash Media Card
To remove the VFlash media, push inward on the card to release it, and pull
the card from the card slot.
iDRAC6 Enterprise Card (Optional)
Installing an iDRAC6 Enterprise Card
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1
Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2
Open the system. See "Opening the System."
3
Remove the plastic filler plug from the system back panel.
4
If installed, remove the expansion card from expansion-card riser 1. See
"Removing an Expansion Card."
5
Install the iDRAC6 Enterprise card:
a
Angle the card so that the RJ-45 connector fits through the back-panel
opening. See
Figure 3-12.
b
Align the front edge of the card with the two front plastic retention
standoffs next to the iDRAC6 connector on the system board, and
lower the card into place. See Figure 3-12 and Figure 6-1.
Page view 100
1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 183 184

Comments to this Manuals

No comments