Dell PowerEdge M1000e Installation Manual download pdf (Page 32)

2-12

Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Hardware Installation Guide

OL-13269-01

Chapter 2 Switch Installation

Configuring the Switch

You have now completed the initial configuration of the switch, and the switch displays its initial

configuration. An example of the output is shown here:

The following configuration command script was created:

hostname switch1

enable secret 5 $1$cagJ$e4LP91PNazfdADoNAZm6y0

enable password

enable_password

line vty 0 15

password

terminal-password

snmp-server community public

interface Vlan1

no shutdown

ip address 10.0.0.1 255.255.255.0

interface FastEthernet0

shutdown

no ip address

interface GigabitEthernet1/0/1

interface GigabitEthernet1/0/2

. . . (output truncated)

interface TenGigabitEthernet1/0/1

interface TenGigabitEthernet1/0/2

end

Step 10 These choices appear:

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

If you want to save the configuration and use it the next time the switch reboots, save it

in NVRAM by selecting option 2.

Enter your selection [2]:2

Make your selection, and press Return.

Step 11 Disconnect the server chassis serial port or the switch console port from the PC. See the “Managing the

Switch” section on page 2-15 for information about configuring and managing the switch.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 71 72

No comments

Dell PowerEdge M1000e Installation Manual Page 32