Dell PowerEdge M1000e Installation Manual download pdf (Page 33)

2-13

Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Hardware Installation Guide

OL-13269-01

Chapter 2 Switch Installation

Configuring the Switch

Using the Device Manager to Configure the Switch

Follow these steps to set up the switch through the device manager. In a browser window, enter the

address that the Fa0 port assigned to the switch. Before you complete the setup program, obtain the

default gateway IP address and the switch password from your system administrator. You can configure

these optional parameters through the Express Setup program:

• Telnet access password

• Names of the SNMP read and write community strings if you are going to use a

network-management program like CiscoWorks

• Host name, system contact, and system location

• System time, time zone, Daylight Savings Time enable

Step 1 On the left side of the device manager GUI, choose Configuration > Express Setup.

The Express Setup page appears (see Figure 2-5 and Figure 2-6). (Close or minimize the device manager

Help window.)

Figure 2-5 Express Setup Page

Step 2 Enter this information in the Network Settings fields.

–

In the Default Gateway field, enter the IP address for the default gateway (router).

–

In the Switch Password field, enter your password. The password can be from 1 to 25

alphanumeric characters, can start with a number, is case sensitive, allows embedded spaces,

but does not allow spaces at the beginning or end.

In the Confirm Switch Password field, enter your password again.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 71 72

No comments

Dell PowerEdge M1000e Installation Manual Page 33