Dell VA-40FC Service Manual download pdf (Page 17)

Fabric OS v6.4.1 Release Notes v1.0 Page 17 of 62

Blade Support

Fabric OS v6.4 software is fully qualified and supports the blades for the 48000 platform noted in the

following table:

48000 Blade Support Matrix

48000 Blade Support Matrix48000 Blade Support Matrix

48000 Blade Support Matrix

Port blade 16, 32 and 48

port 4Gbit blades

(FC4-16, FC4-32, FC4-48), 16, 32 and 48-port

8Gbit blade (FC8-16, FC8-32, FC8-48), and the

6-port 10G FC blade (FC10-6)

Supported with any mix and up to 8 of each. No

restrictions around intermix. The 48000 must run Fabric

OS v6.0 or later to support the FC8-16 port blade and

Fabric OS v6.1 or later to support the FC8-32 and FC8-48

port blades.

Note:

Note:Note:

Note: FC8-64 is not supported on 48000.

Intelligent blade

Up to a total of 4 Intelligent blades (includes iSCSI,

FCIP/FCR and Application blade), FC4-16IP, FR4-18i, and

FA4-18 respectively. See below for intermix limitations,

exceptions, and a max of each blade.

iSCSI blade (FC4

16IP)

Up to a maximum of 4 blades of this type.

IP/FC Router blade (FR4

18i)

Up to a maximum of 2 blades of this type. This can be

extended under special circumstances but must be

approved by Brocade’s Product Team. Up to 8 FR4-18i

blades can be installed if they are used only for FC

FastWrite or FCIP without routing.

Virtualization/Application Blade (FA4

18)

Up to a maximum of 2 blades of this type.

Encryption Blade

(FS8

18), Extension Blade

(FX8-24), FCoE/CEE Blade (FCOE10-24)

Not supported.

Fabric OS v6.4 software is fully qualified and supports the blades for the DCX/DCX-4S noted in the following

table

DCX/DCX

DCX/DCXDCX/DCX

DCX/DCX-

-4S Blade Support Matrix

4S Blade Support Matrix 4S Blade Support Matrix

4S Blade Support Matrix

, 32, 48 and 64

port

8Gbit port blades (FC8

16, FC8-32, FC8-48, FC8-64) and the 6-port 10G

FC blade (FC10-6)

16, 32 and 48 port blades are supported with FOS v6.0

and above, 64 port blade is supported starting with FOS

v6.4.0, with any mix and up to 8/4 of each.

No restrictions around intermix.

Intelligent blade

Up to a total of 8/4 intelligent blades. See below for

maximum supported limits of each blade.

IP/FC Router blade (FR4

18i)

Up to a maximum of 4 blades of this type. This can be

extended under special circumstances, but must be

approved by Brocade’s Product Team. Up to 8 FR4-18i

blades can be installed in a DCX if they are used only for

FC FastWrite or FCIP without routing.

Virtualization/Application Blade (FA4

18)

Up to a maximum of 4 blades of this type.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 61 62

Comments to this Manuals

No comments

Dell VA-40FC Service Manual Page 17

Comments to this Manuals

Related products and manuals for Network switches Dell VA-40FC