Dell PowerEdge 800 Service Manual Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 87
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
1. Insert the control panel cable through the front of the system and connect the cable connector to the FRONT_PANEL connector on the system board.
2. Using a #2 Phillips screwdriver, install the screws that secure the control panel assembly to the chassis. See FigureC-1.
3. Close the system. See "Replacing the Cover" in "Troubleshooting Your System."
4. Lift the system upright.
5. Reinstall the bezel. See "Installing the Bezel" in "Troubleshooting Your System."
6. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Chassis-Intrusion Switch
Removing the Chassis-Intrusion Switch
1. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the bezel. See "Removing the Bezel" in "Troubleshooting Your System."
3. Lay the system on its right side.
4. Remove the cover. See "Removing the Cover" in "Troubleshooting Your System."
5. Disconnect the fan power cable from the FRONT_FAN connector on the system board. See FigureC-2.
Figure C-2. Removing the Chassis-Intrusion Switch
6. Compress the two release tabs on the top of the front fan assembly and lift the fan assembly away from the system. See FigureC-2.
7. Disconnect the chassis-intrusion switch cable from the INTRUSION_SWITCH connector on the system board. See FigureC-2.
8. Slide the chassis-intrusion switch upward out of its slot in the front panel, and guide the switch cable through the expansion-card guide bracket and
front panel.
Replacing the Chassis-Intrusion Switch
1. Thread the chassis-intrusion switch cable through the holes in the front panel and expansion-card guide bracket.
CAUTION: See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 86 87

Comments to this Manuals

No comments