Dell PowerVault DL2000 User Manual Page 78
- Page / 188
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
78 Installing System Components
Removing the Power Supply Blank
Using a Phillips screwdriver, remove the screw on the left side of the blank,
rotate the blank slightly to clear the bay, and remove from the chassis.
NOTICE: To ensure proper system cooling, the power supply blank must be
installed on the unoccupied power supply bay in a non-redundant configuration.
Remove the power supply blank only if you are installing a second power supply.
Installing the Power Supply Blank
To install the power supply blank, insert the tab on the right edge of the blank
into the slot in the power supply bay wall. Rotate the blank into the power
supply bay and secure with the Phillips screw.
System Fans
The system includes four hot-pluggable cooling fans.
Removing a System Fan
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
NOTICE: The system fans are hot-pluggable. To maintain proper cooling while the
system is on, replace only one fan at a time.
1
Open the system. See "Opening the System" on page 67.
CAUTION: Use caution when handling the fan until the fan blades stop spinning.
2
Raise the fan handle and pull the fan straight up from the fan cage to clear
the chassis. See Figure 3-8.
Book.book Page 78 Monday, September 14, 2009 12:57 PM
- Hardware Owner’s Manual 1
- Notes, Notices, and Cautions 2
- Contents 3
- 4 Contents 4
- 6 Contents 6
- 8 Contents 8
- 10 Contents 10
- About Your System 11
- 14 About Your System 14
- Hard-Drive Indicator Codes 15
- Power Indicator Codes 18
- NIC Indicator Codes 19
- LCD Status Messages 20
- N/A SYSTEM NAME 21
- The SYSTEM NAME 21
- 22 About Your System 22
- NOTE: The LCD continues to 23
- 24 About Your System 24
- 26 About Your System 26
- 28 About Your System 28
- 30 About Your System 30
- Removing LCD Status Messages 31
- System Messages 32
- 34 About Your System 34
- 36 About Your System 36
- 38 About Your System 38
- 40 About Your System 40
- 42 About Your System 42
- Warning Messages 43
- Diagnostics Messages 44
- Alert Messages 44
- Responding to Error Messages 45
- System Setup Options 46
- Memory Information Screen 49
- CPU Information Screen 50
- Integrated Devices Screen 51
- Serial Communication Screen 53
- System Security Screen 53
- Exit Screen 56
- Using the System Password 56
- Assigning a System Password 57
- Using the Setup Password 59
- Entering the BMC Setup Module 61
- BMC Setup Module Options 61
- Inside the System 64
- Front Bezel 65
- Replacing the Front Bezel 66
- Opening the System 67
- Closing the System 67
- Hard Drives 68
- Before You Begin 69
- Removing a Drive Blank 69
- Installing a Drive Blank 70
- Hard-Drive Carrier 73
- SATAu SAS 75
- Power Supplies 76
- Replacing a Power Supply 77
- System Fans 78
- Replacing a Cooling Fan 79
- Cooling Shroud 80
- Fan Brackets 81
- Replacing the Fan Bracket 82
- Cable Routing 83
- SAS Controller Daughter Card 85
- Configuring the Boot Device 87
- Expansion Cards 88
- Removing an Expansion Card 90
- Expansion-Card Cage 91
- DRAC Card and Cables 93
- Optical Drive and Cable 96
- Installing the Optical Drive 97
- System Memory 100
- Memory Sparing Support 101
- Memory Mirroring Support 101
- Installing Memory Modules 102
- Removing Memory Modules 104
- Processors 105
- Installing a Processor 108
- System Battery 110
- Expansion-Card Riser Boards 112
- Sideplane Board 116
- SAS Backplane Board 118
- Removing the System Board 124
- Installing the System Board 127
- Installing System Components 128
- Troubleshooting Your System 129
- Checking the Equipment 130
- Troubleshooting the Keyboard 132
- Troubleshooting the Mouse 133
- Troubleshooting a USB Device 134
- Troubleshooting a NIC 136
- Troubleshooting a Wet System 137
- Troubleshooting a Fan 141
- Troubleshooting System Memory 142
- Troubleshooting a Hard Drive 146
- System Diagnostics Features 153
- Using the Custom Test Options 155
- Jumpers and Connectors 157
- System Board Connectors 158
- 160 Jumpers and Connectors 160
- Sideplane Board Connectors 162
- PCI Buses 162
- Jumpers and Connectors 165 165
- 166 Jumpers and Connectors 166
- Getting Help 167
- 168 Getting Help 168
- Glossary 169
- 170 Glossary 170
- 172 Glossary 172
- 174 Glossary 174
- 176 Glossary 176
- 178 Glossary 178
- 180 Glossary 180
- Index 181 181
- Index 183 183
- Index 185 185
- Index 187 187
- 188 Index 188
Related products and manuals for Servers Dell PowerVault DL2000
(58 pages)
Servers Dell PowerEdge R510 User Manual
(24 pages)
(24 pages)
Servers Dell PowerEdge C5220 How to Use
(60 pages)
(60 pages)
Servers Dell PowerEdge C6100 Owner's Manual
(160 pages)
(160 pages)
Servers Dell PowerEdge R415 Owner's Manual
(188 pages)
(188 pages)
Servers Dell PowerEdge SL300 User Manual
(41 pages)
(41 pages)
Servers Dell POWEREDGE R515 Owner's Manual
(194 pages)
(194 pages)
Servers Dell PowerEdge 800 Service Manual
(87 pages)
(87 pages)
Servers Dell DR4100 User Manual
(119 pages)
(119 pages)
Servers Dell R2 User Manual
(34 pages)
(34 pages)
Servers Dell PowerEdge R720 White Paper
(17 pages)
(17 pages)
Servers Dell R2 User Manual
(32 pages)
(32 pages)
Servers Dell PowerEdge C6145 Owner's Manual
(250 pages)
(250 pages)
Servers Dell PowerEdge R715 Owner's Manual
(190 pages)
(190 pages)
© 2020, manymanuals.com. All rights reserved. | 2.759 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals