Dell POWEREDGE 840 User Manual Page 62

  • Download
  • Add to my manuals
  • Print
  • Page
    / 158
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 61
62 Installing System Components
Figure 3-12. Installing the SAS Backplane Board
5
Connect the power cable connector P3 to the power connector on the SAS backplane. See Figure 3-12.
6
Connect the baseboard management controller (BMC) inter-IC (I2C) cable to the SAS backplane. See
Figure 3-12.
7
Connect the other end of the BMC I2C cable to connector BP_I2C on the system board. See "System
Board Connectors" on page 118.
8
If not already installed, install the SAS controller card.
See "Installing an Expansion Card" on page 72 for instructions about installing the card.
9
Connect the SAS data cable to the SAS controller card, and to the SAS interface connector on the
backplane. See Figure 3-13 and
Figure 3-12.
10
Close the system. See "Closing the System" on page 47.
11
Stand the system upright.
1 release tab 2 power connector 3 I2C connector
4 data cable 5 power cable
1
5
2
4
3
Page view 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 157 158

Comments to this Manuals

No comments