Dell PowerEdge 800 Service Manual download pdf (Page 67)



10. If a controller card was supplied with the drive, install the controller card in expansion slot 3, 4, or 5. See "Installing an Expansion Card" in "Installing

System Components."



11. Connect a power cable to the drive. See Figure7-3.



12. Connect the interface cable to the drive and to the appropriate connector on the system board or controller card (if applicable).

If you are installing an IDE device (such as an optical drive), connect the interface cable to the IDE device and the IDE connector on the system board.

See Figure7-4.

If you are installing a SCSI device in the second drive bay (such as a tape backup device), connect the interface cable to the device and to channel A on

the SCSI controller card. See Figure7-4.

See FigureA-3 to locate the system board connectors.

Figure 7-4. Connecting a Tape Drive to a SCSI Controller Card



13. Ensure that all cables are firmly connected and arranged so that they will not catch on the computer cover or block airflow inside the system.



14. Install the cooling shroud. See "Installing the Cooling Shroud" in "Installing System Components."



15. Install the cover. See "Replacing the Cover" in "Troubleshooting Your System."



16. Stand the system upright.



NOTE: See the documentation that is included with the controller card for more information.

NOTE: A SCSI device attached to a SCSI controller card and an IDE device attached to the system board can be installed together as shown in

Figure7-4.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 86 87

Comments to this Manuals

No comments

Dell PowerEdge 800 Service Manual Page 67

Comments to this Manuals

Related products and manuals for Servers Dell PowerEdge 800