Dell R430 Owner's Manual Page 106

  • Download
  • Add to my manuals
  • Print
  • Page
    / 155
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 105
Installing an expansion card
Installing the expansion-card riser
Hard-drive backplane
Depending on your system configuration:
PowerEdge
R430 supports
3.5 inch or 2.5 inch (x4) SAS/SATA backplane or
2.5 inch (x8) SAS/SATA backplane or
2.5 inch (x10) SAS/SATA backplane
Removing the hard-drive backplane
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: To prevent damage to the drives and backplane, you must remove the hard drives
from the system before removing the backplane.
CAUTION: You must note the number of each hard drive and temporarily label them before
removal so that you can replace them in the same locations.
1. Ensure that you read the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove all hard drives.
Steps
1. Disconnect the SAS/SATA data, signal, and power cable(s) from the backplane.
2. Press the release tabs and lift the backplane upward and slide it toward the back of the chassis.
106
Page view 105
1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 154 155

Comments to this Manuals

No comments