Dell R430 Owner's Manual Page 76

  • Download
  • Add to my manuals
  • Print
  • Page
    / 155
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 75
Steps
1. Align the two notches on the metal standoffs with the slots on the side of the optical drive.
2. Slide the optical drive into the notches until it is seated firmly and the release latch snaps into place.
3. Connect the power cable.
4. Connect the data cable to the back of the drive and to the SATA connector on the system board.
NOTE: Route and secure the cables using the cable routing latch on the system chassis to
prevent them from being pinched or crimped.
Next steps
Follow the procedure listed in After working inside your system.
Cooling fans
Your system supports:
Up to five cooling fans in a non-redundant power supply configuration.
Up to six cooling fans in a redundant power supply configuration.
NOTE: Fan 1 must be installed in a redundant power supply configuration.
NOTE: Hot-swap removal or installation of the fans is not supported.
NOTE: Each fan is listed in the system’s management software, referenced by the respective fan
number. If there is a problem with a particular fan, you can easily identify and replace the proper fan
by noting the fan numbers on the cooling fan assembly.
Removing a cooling fan
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: The procedure for removing each fan is identical.
1. Ensure that you read the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. If installed, remove the cooling shroud.
Steps
1. Disconnect the fan's power cable from the power cable connector on the system board or power
interposer board as applicable.
2. Lift the fan out of the cooling-fan bracket.
76
Page view 75
1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 154 155

Comments to this Manuals

No comments