Dell PowerConnect W-AirWave 7.6 User Manual download pdf (Page 158)

146 | Discovering, Adding, and Managing Devices Dell PowerConnect W-AirWave 7.6 | User Guide

Figure 108: View Device Credentials Window

NOTE: The View Device Credentials message may appear slightly different depending on the vendor and model.

5. If the credentials are incorrect, return to the Device Communications area on the APs/Devices > Manage page.

Enter the appropriate credentials, and select Apply.

6. Return to the APs/Devices > List page to see if the device appears with a Status of Up.

Setting up Spectrum Analysis in AirWave

The spectrum analysis software modules on Dell PowerConnect W-Series AP models AP-105, RAP-5WN, the AP-

12x series, the AP-13x series and the AP-9x series can examine the radio frequency (RF) environment in which the

Wi-Fi network is operating, identify interference and classify its sources.

The spectrum analyzer is used in conjunction with Dell's Adaptive Radio Management (ARM) technology. While

the spectrum analyzer identifies and classifies Wi-Fi and non-Wi-Fi sources of interference, ARM automatically

ensures that APs serving clients will stay clear of interference.

Individual APs or groups of APs can be converted to dedicated spectrum monitors through the dot11a and dot11g

radio profiles of that AP or AP group, or through a special spectrum override profile.

Each 802.11a and 802.11g radio profile references a spectrum profile, which identifies the spectrum band the radio

will monitor and analyze, and defines the default ageout times for each monitored device type. By default, an

802.11a radio profile references a spectrum profile named default-a (which configures the radio to monitor the upper

channels of the 5 GHz radio band), and an 802.11g radio profile references a spectrum profile named default-g

(which configures the radio to monitor all channels the 2.4 GHz radio band).

Most interference will occur in the 2.4 GHz radio band.

For more information about Spectrum analysis and ARM technology, refer to the

Dell PowerConnect W-Series

ArubaOS User Guide

at dell.com/support/manuals.

Spectrum Configurations and Prerequisites

The following prerequisites must be in place to configure an AP to run in Spectrum mode in AirWave:

l The AP must be in Manage Read/Write mode.

l The AP’s associated controller must have an RFprotect license and must be running ArubaOS 6.0 or later.

l Dell PowerConnect W GUI Config must be enabled for that AP’s group in the Groups > Basic page.

There are three main situations in which you would set one or more devices to Spectrum mode in AirWave:

l Dell PowerConnect W AP Groups running permanently with the default Spectrum profile

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 331 332

No comments

Dell PowerConnect W-AirWave 7.6 User Manual Page 158