Dell PowerConnect W-AirWave 7.6 User Manual download pdf (Page 78)

66 | Configuring and Using Device Groups Dell PowerConnect W-AirWave 7.6 | User Guide

Setting Default Description

on this

AMP

l All Devices—AirWave displays all Group tabs and setting options.

l Only devices in this group—AirWave hides all options and tabs that do not apply to the

devices in the group. If you use this setting, then to get the group list to display the

correct SSIDs for the group, you must Save and Apply on the group.

l Only devices on this AMP— hides all options and tabs that do not apply to the APs and

devices currently on AirWave.

l Use system defaults—Use the default settings on AMP Setup > General

l Selected device types—Allows you to specify the device types for which AirWave

displays Group settings.

Selected Device

Types

N/A

This option appears if you chose to display selected device types, allowing you to select the

device types to display group settings. Use Select devices in this group to display only

devices in the group being configured.

8. To assign dynamically a range of static IP addresses to new devices as they are added into the group, locate the

Automatic Static IP Assignment section on the Groups > Basic configuration page. If you select Yes in this

section, additional fields appear. Complete these fields as required. Table 43 describes the settings and default

values This section is only relevant for a small number of device types, and will appear when they are present.

Setting Default Description

Assign Static IP

Addresses to

Devices

Specify whether to enable AirWave to statically assign IP addresses from a specified range

to all devices in the Group. If this value is set to Yes, then the additional configuration fields

described in this table will become available.

Start IP Address none Sets the first address AirWave assigns to the devices in the Group.

Number of

Addresses

none Sets the number of addresses in the pool from which AirWave can assign IP addresses.

Subnet Mask none Sets the subnet mask to be assigned to the devices in the Group.

Subnet Gateway none Sets the gateway to be assigned to the devices in the Group.

Next IP Address none

Defines the next IP address queued for assignment. This field is disabled for the initial

Access Points group.

Table 43:

Automatic Static IP Assignment Fields and Default Values

9. To configure Spanning Tree Protocol on WLC devices and Proxim APs, locate the Spanning Tree Protocol

section on the Groups > Basic configuration page. Adjust these settings as required. Table 44 describes the

settings and default values.

Setting Default Description

Spanning Tree

Protocol

Specify wehther to enable or disables Spanning Tree Protocol on Proxim APs.If this value

is set to Yes, then the additional configuration fields described in this table will become

available.

Bridge Priority 32768

Sets the priority for the AP. Values range from 0 to 65535. Lower values have higher

priority. The lowest value is the root of the spanning tree. If all devices are at default the

device with the lowest MAC address will become the root.

Table 44:

Spanning Tree Protocol Fields and Default Values

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 331 332

Comments to this Manuals

No comments

Dell PowerConnect W-AirWave 7.6 User Manual Page 78

Comments to this Manuals

Related products and manuals for Software Dell PowerConnect W-AirWave 7.6