Dell PowerConnect W-AirWave 7.6 User Manual download pdf (Page 295)

Figure 208: Drawing a wall

3. To move or resize the wall, select the Draw Walls button in the Edit menu again. The cursor changes to a hand,

and the ends of the wall is highlighted. Click and drag the end point handles to change the wall, as shown in

Figure 209:

Figure 209: Moving and resizing an existing wall

n To change the attenuation of a wall, right-click the wall and select the appropriate building material.

n To delete a wall, select the wall and press the Delete key. You can also right-click on a wall and select

Delete This Wall from the popup menu.

4. Once all walls are provisioned on the floor plan, select Save (floppy disk icon above the zoom bar).

NOTE: Drawing only outside walls is recommended. If you are seeing inaccurate client locations or heat maps after entering exterior

walls, proceed to Client Surveys. If you still experience problems, then you can proceed to adding interior walls.

Location Training for Stationary Devices

QuickView provides the ability to statically assign a permanent

x,y

coordinate to stationary devices like PCs, Scales,

and Point-of-Sale terminals. This will reduce the calculation requirements on the VisualRF location service and

increase the accuracy of the RF characteristics of individual floor plans.

1. Drag the client device to the proper location.

2. Select the device and a popup menu appears. From that menu, select Surveys and Training.

3. Click the Add button for Static Training, as shown in Figure 210:

Dell PowerConnect W-AirWave 7.6 | User Guide Using VisualRF | 283

1 2 ... 290 291 292 293 294 295 296 297 298 299 300 ... 331 332

No comments

Dell PowerConnect W-AirWave 7.6 User Manual Page 295