Dell Force10 S60-44T Installation Manual download pdf (Page 14)

Install the S60 System | 14

Insert Optional Modules

The S60 system has expansion slots at the front left and rear right of the system that you can use for

stacking modules or for Small Form-Factor Pluggable Plus (SFP+) devices.

Table 3-1

lists the optional

modules that you can install into these expansion slots. The optional modules are hot-swappable.

NOTE: Pre-configuring the interfaces for the optical module preserves the configuration if and when you

remove an optical module. The optional 10G optical module is automatically recognized and the interfaces are

created when you insert the module into the slot. However, if the system is not already configured for the

interfaces, when you remove the optional module, the interfaces and their configurations are removed as well.

WARNING: ESD damage can occur if the components are mishandled. Always wear an ESD-preventive wrist

or heel ground strap when handling the S60 system and its components.

To install an optional module, follow these steps:

Table 3-1. Optional Modules

Module Description

2-port, 12G stacking module

1-port, 24G stacking module

2-port, 10G SFP+ optical module

Step Task

1 Remove the faceplate covering the module slot located at the rear left or front right of the S60 system.

2 Remove the optional module from its packaging.

3 Slide the optional module into the slot.

4 Secure the captive screw on the side of the optional module.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 44 45

No comments

Dell Force10 S60-44T Installation Manual Page 14