Dell Force10 S60-44T Installation Manual download pdf (Page 6)

The S60 System | 6

The S60 System

Introduction

The Dell Networking S60 system is a high-performance, high-capacity, low-cost, stackable, Layer 2

switch/Layer 3 router that supports 44 built-in 10/100/1000 Base-T ports, four Small Form-Factor

Pluggable (SFP) ports, an optional Small Form-Factor Pluggable Plus (SFP+) module, and optional 12G

or 24G stacking modules.

The front of the S60 (

Figure 2-1

) contains the Power Supply Units (PSUs), optional module slots, and the

grounding connectors. The rear of the S60 (

Figure 2-2

) contains the 44 ethernet ports, optional module

ports, management ports, and displays for alarms and stacking identification.

Figure 2-1. The Front of the S60 System

Figure 2-2. The Rear of the S60 System

NOTE: The ethernet ports are labeled 0-43. When cabling these ports, be sure not to interfere with the airflow

from the small vent holes above and below the ports.

Power Supply (PSU0)

Power Supply (PSU1)

Mounting Bracket Mounting Bracket

Optional Module

(OPT1)

Ground Connectors

Power Connector

(AC shown)

Fans

Ethernet Ports

SFP Ports

Optional

Module

(OPT0)

Management

Ports

Stack ID

Alarm

LEDs

1 2 3 4 5 6 7 8 9 10 11 ... 44 45

No comments

Dell Force10 S60-44T Installation Manual Page 6