Dell Force10 S60-44T Installation Manual download pdf (Page 37)

S60 Specifications | 37

Figure 7-1. The European WEEE symbo

In accordance with the European WEEE Directive, electrical and electronic equipment (EEE) is to be

collected separately and to be reused, recycled, or recovered at end of life. Users of EEE with the WEEE

marking per Annex IV of the WEEE Directive, as shown above, must not dispose of end of life EEE as

unsorted municipal waste, but use the collection framework available to customers for the return,

recycling and recovery of WEEE. Customer participation is important to minimize any potential effects

of EEE on the environment and human health due to the potential presence of hazardous substances in

EEE.

Dell Networking products, which fall within the scope of the WEEE, are labeled with the crossed-out

wheelie-bin symbol, as shown above, as required by WEEE.

For information on Dell Networking product recycling offerings, see the WEEE Recycling instructions

at:

http://www.euro.dell.com/recycling

For more information, contact the Dell Networking Technical Assistance Center (TAC) (see

Contacting

the Technical Assistance Center

SD Card Removal

To support high-security environments, you can remove and re-install the SD card. Dell Networking

recommends only removing the card when necessary. Only authorized personnel should remove and

replace the card.

CAUTION: Only remove the SD card to support high-security operations and after discussions with Dell

Networking Technical Support or your Dell Networking representative.

To remove the SD card, follow these steps:

Step Task

1 Remove the small Phillips screws that connect the top to the body. There are three screws evenly spaced across

the rear and three screws evenly spaced along each side of the case.

2 Slide the top backwards until its front flange slides free of the faceplate. Lift it off.

3 Gently push the SD card to release it from the slot.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44 45

No comments

Dell Force10 S60-44T Installation Manual Page 37