Dell Force10 S60-44T Installation Manual download pdf (Page 5)

About this Guide | 5

About this Guide

This guide provides site preparation recommendations, step-by-step procedures for rack mounting and

desk mounting, inserting optional modules, and connecting to a power source.

After you have completed the hardware installation and power-up of the S60 system, for software

configuration information, refer to the FTOS Configuration Guide for the S60 System and for Command

Line Interface (CLI) information, refer to the FTOS Command Line Reference Guide for the S60 System.

NOTE: For information about upgrading your system, refer to the S60 Release Notes. For questions regarding

FTOS versions and upgrades, contact Dell Networking Technical Support.

CAUTION: To avoid electrostatic discharge (ESD) damage, wear grounding wrist straps when handling the

S60 system.

WARNING: Only trained and qualified personnel can install the S60 system. Read this guide before installing

and powering up this equipment. The S60 system contains two power cords. Disconnect both power cords

before servicing.

WARNING: This equipment contains optical transceivers, which comply with the limits of Class 1 laser

radiation.

WARNING: When no cable is connected, visible and invisible laser radiation may be emitted from the

aperture of the optical transceiver ports. Avoid exposure to laser radiation and do not stare into open

apertures.

Related Publications

For more information about the S60 system, refer to the following documents:

• FTOS Configuration Guide for the S60 System

• FTOS Command Line Reference Guide for the S60 System

•

FTOS Release Not

for the S60 System

NOTE: For the most recent documentation and software, visit iSupport (registration for access to some

sections is required):

https://www.force10networks.com/CSPortal20/Main/SupportMain.aspx

1 2 3 4 5 6 7 8 9 10 ... 44 45

No comments

Dell Force10 S60-44T Installation Manual Page 5