Access the Console Ports | 30
To access the USB-B console port, follow these steps:
Step Task
1 Power on the PC (Dell Force 10 recommends using an XP operating system).
2 Connect the USB-A end of cable (included) into an available USB port on the PC.
3 Connect the USB-B end of cable into the USB-B console port on the S60 system.
4 Power on the S60 system.
5 Install the necessary USB device drivers (an internet connection is required). For assistance, contact Dell
Networking Technical Support.
6 Open your terminal software emulation program to access the S60 system.
7 Set the terminal connection settings as follows:
• 9600 baud rate
• No parity
• 8 data bits
•1 stop bit
• No flow control
8 The CLI command prompt appears when you are connected to the S60 system.
Comments to this Manuals