Dell 1000W User's Guide download pdf (Page 129)

129

Installation on a VMware ESXi Server

NOTE: All hardware elements must have an operational network configuration that allows them to

communicate freely with each other. The Dell UPS Management Software uses TCP and UDP for

communication with UPS.

4 Confirm that the following UDP ports are enabled on the VIMA/vMA firewall: 161, 162, and 3369

Example commands:

sudo iptables I INPUT p udp dport 161 j ACCEPT

sudo iptables I OUTPUT p udp dport 161 j ACCEPT

5 Confirm that the following TCP port is enabled on the VIMA/vMA firewall: 2099

Dell UPS Management Software Installation

To install the software:

1 Start the vMA 4.0 guest operating system.

2 Download the software from the Dell Web site (support.dell.com) or from the CD (F618R A04 or

higher) provided with the UPS.

3 Upload the software from Windows to vMA 4.0 using WinSCP tools.

4 Copy the Linux and InstallerData files from the CD to vMA.

5 Enter the following commands to access the Linux and InstallerData files:

sudo chmod R 777 Linux

sudo chmod R 777 InstallerData

6 Enter the Linux path and then enter the following command to install the software:

cd Linux

sudo ./setup_console.bin

7 Edit the document “VMwareESXHosts” on the installation path.

Add all ESXi server host IP addresses, separated by spaces. Add the IP address of the ESXi server

on which VIMA/vMA is installed as the last entry.

Example: 172.18.127.13 172.18.127.12 172.18.127.11

NOTE:

To configure each server, see “vMA Configuration” on page 120.

8 Start the Agent. From the installation path, enter the command:

sudo ./agent start

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 135

No comments

Dell 1000W User's Guide Page 129