Dell PowerEdge SC1435 User Manual Page 20

  • Download
  • Add to my manuals
  • Print
  • Page
    / 132
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 19
20 About Your System
Read fault
Requested sector not
found
The operating system cannot read
from the diskette or hard drive, the
system could not find a particular
sector on the disk, or the requested
sector is defective.
Replace the diskette. Ensure that the
diskette and hard drive cables are
properly connected. See
"Troubleshooting a USB Device" on
page 71, "Troubleshooting an Optical
Drive" on page 78, or "Troubleshooting
a Hard Drive" on page 78 for the
appropriate drive(s) installed in your
system.
Remote configuration
update attempt failed
System unable to process Remote
Configuration request.
Retry Remote Configuration.
ROM bad checksum =
address
Expansion card improperly installed
or faulty.
Reseat the expansion cards. Ensure
that all appropriate cables are securely
connected to the expansion cards. If
the problem persists, see
"Troubleshooting an Expansion Card"
on page 80.
SATA port
n
hard disk
drive not found
SATA cables are not properly seated,
or drive missing.
See "Troubleshooting a Hard Drive" on
page 78.
Sector not found
Seek error
Seek operation failed
Faulty diskette or hard drive. See "Troubleshooting a USB Device"
on page 71 or "Troubleshooting a Hard
Drive" on page 78 for the appropriate
drive.
Shutdown failure Shutdown test failure. See "Troubleshooting System Memory"
on page 76.
The amount of system
memory has changed
Memory has been added or removed
or a memory module may be faulty.
If memory has been added or removed,
this message is informative and can be
ignored. If memory has not been added
or removed, check the SEL to
determine if single-bit or multi-bit
errors were detected and replace the
faulty memory module. See
"Troubleshooting System Memory" on
page 76.
This system supports only
Opteron 2000 series
processors.
Microprocessor(s) is not supported
by the system.
Install a supported microprocessor or
microprocessor combination. See
"Processors" on page 50.
Time-of-day clock stopped Faulty battery or faulty chip. See "Troubleshooting the System
Battery" on page 74.
Table 1-6. System Messages (continued)
Message Causes Corrective Actions
Page view 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 131 132

Comments to this Manuals

No comments