Dell PowerEdge SC1435 User Manual download pdf (Page 43)

Installing System Components 43

Figure 3-6. Removing and Installing a Power Supply

Installing the Power Supply

NOTICE: On a rack system, you may need to temporarily unlatch and lift the cable management arm. For

information about the cable management arm, see the system’s Rack Installation Guide.

NOTICE: For more information about the power cable retention bracket, see Getting Started With Your System.

Lower the power supply into the system and slide the power supply into place against the back panel of

the system. See Figure 3-6.

Reinstall the screw that secures the power supply to the chassis.

Connect the two power supply cables to the POWER1 and POWER2 connectors on the system board.

See Figure 3-6.

If applicable, route the hard drive power cables through the oval opening in the chassis brace and

connect them to the hard drives.

Close the system. See "Closing the System."

1 hard-drive power cables (2) 2 retention screw 3 power supply

4 POWER2 connector 5 POWER1 connector

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 131 132

No comments

Dell PowerEdge SC1435 User Manual Page 43