Dell PowerEdge SC1435 User Manual Page 56
- Page / 132
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
56 Installing System Components
Optional SAS RAID Controller
If you install the optional SAS RAID controller card, you can install two SAS or SATA hard drives and
configure them for RAID 0 or RAID 1 operation.
• See "Expansion Cards" on page 44 for information on installing the optional SAS RAID controller card.
• See the RAID controller card documentation for information about the RAID configuration utility.
Before You Begin
You may need to use different programs than those provided with the operating system to partition and
format SAS or SATA hard drives.
NOTICE: Do not turn off or reboot your system while the drive is being formatted. Doing so can cause a drive
failure.
When you format a high-capacity hard drive, allow enough time for the formatting to be completed. Long
format times for these drives are normal.
Installing a Hard Drive
1
If you are replacing an existing hard drive, disconnect the data and power cables from the back of the
drive. See Figure 3-12.
2
To remove the drive carrier from the system, press inwards on the release tabs on each side of the
carrier and lift the carrier from the system. See Figure 3-12.
3
If you are replacing an existing hard drive, deflect the sides of the carrier outward and separate the hard
drive from the carrier.
4
To install the new hard drive in the carrier, fit the left edge of the drive into the carrier, then lower the
right edge of the drive into the carrier until the pins fit into the corresponding holes in the drive.
See
Figure 3-12
.
5
Reinstall the drive carrier into the system.
6
Connect the data cable to the back of the drive.
7
Connect the other end of the cable to the drive controller:
• If you are connecting the drive to the optional SAS controller card, route the SAS data cable
though the oval opening in the chassis brace and connect the cable to the data connector on the
controller card. Secure the data cable to the clips on the edge of the cooling shroud.
• If you are connecting the drive to the SATA controller on the system board, route the SATA data
cable though the oval opening in the chassis brace and connect the cable to SATA connector SATA
A or SATA B. See Figure 6-2.
8
Connect the power cable to the back of the drive. See Figure 3-12.
- Hardware Owner’s Manual 1
- Notes, Notices, and Cautions 2
- Contents 3
- 4 Contents 4
- 6 Contents 6
- 8 Contents 8
- About Your System 9
- 12 About Your System 12
- Power Indicator Codes 13
- NIC Indicator Codes 14
- Diagnostics Indicator Codes 14
- System Messages 16
- 18 About Your System 18
- 20 About Your System 20
- Warning Messages 22
- Diagnostics Messages 22
- Alert Messages 22
- Responding to Error Messages 23
- System Setup Options 24
- Memory Information Screen 27
- CPU Information Screen 27
- Integrated Devices Screen 28
- System Security Screen 29
- Exit Screen 30
- Using the System Password 30
- Using the Setup Password 32
- Entering the BMC Setup Module 34
- BMC Setup Module Options 34
- Installing System Components 35
- Inside the System 36
- Opening the System 38
- Cooling Shroud 39
- Cooling Fan Modules 40
- Power Supply 42
- Installing the Power Supply 43
- Expansion Cards 44
- Removing an Expansion Card 45
- System Memory 46
- Installing Memory Modules 48
- Removing Memory Modules 49
- Processors 50
- Installing a Processor 52
- Optical Drive 54
- Hard Drives 55
- Optional SAS RAID Controller 56
- Before You Begin 56
- Installing a Hard Drive 56
- Configuring the Boot Device 57
- Expansion-Card Riser 58
- System Battery 59
- Removing the Control Panel 61
- Installing the Control Panel 62
- Removing the System Board 63
- Installing a System Board 64
- Troubleshooting Your System 67
- Checking Basic Power Problems 68
- Checking the Equipment 68
- Troubleshooting the Keyboard 70
- Troubleshooting the Mouse 70
- Troubleshooting a USB Device 71
- Troubleshooting a NIC 72
- Troubleshooting a Wet System 72
- Troubleshooting a Fan 75
- Troubleshooting System Memory 76
- Troubleshooting a Hard Drive 78
- System Diagnostics Features 85
- Using the Custom Test Options 87
- Jumpers and Connectors 89
- Jumpers and Connectors 91 91
- System Board Connectors 92
- Riser Boards 94
- Getting Help 95
- AutoTech Service 96
- Technical Support Service 96
- Problems With Your Order 97
- Product Information 97
- Before You Call 98
- Contacting Dell 100
- 102 Getting Help 102
- 104 Getting Help 104
- 106 Getting Help 106
- 108 Getting Help 108
- 110 Getting Help 110
- 112 Getting Help 112
- 114 Getting Help 114
- 116 Getting Help 116
- 118 Getting Help 118
- Printers, and Projectors 119
- 120 Getting Help 120
- Glossary 121
- 122 Glossary 122
- 124 Glossary 124
- 126 Glossary 126
- 128 Glossary 128
- Index 129 129
- 130 Index 130
- Index 131 131
- 132 Index 132
Related products and manuals for Computer hardware Dell PowerEdge SC1435
(24 pages)
Computer hardware Dell UPS 2700R User Manual
(28 pages)
(28 pages)
© 2020, manymanuals.com. All rights reserved. | 1.148 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals