Dell PowerEdge SC1435 User Manual download pdf (Page 64)

64 Installing System Components

Figure 3-16. System Board Removal

Installing a System Board

Install the heatsink(s) and microprocessor(s). See "Installing a Processor" on page 52

Install the memory modules in their original locations. See "Installing Memory Modules" on page 48.

Lower the system-board tray into the system until the tray sits flat on the bottom of the chassis.

Slide the system-board tray toward the back of the chassis until the system board release pin locks into

position.

Connect the control panel cable to the system board. See Figure 6-2.

If applicable, connect the optical drive cable to the system board. See Figure 6-2.

Reinstall the power supply. See "Installing the Power Supply" on page 43.

Replace the riser board. See "Installing an Expansion-Card Riser" on page 59.

Replace any expansion card(s). See "Installing an Expansion Card" on page 44.

Reconnect the two fan module power cables to the system board. See "Removing and Installing a

Cooling Fan Module" on page 41.

Replace the cooling shroud. See "Replacing the Cooling Shroud" on page 40.

1 system board release pin 2 system board attached to

system-board tray

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 131 132

No comments

Dell PowerEdge SC1435 User Manual Page 64