Dell OptiPlex 170L Specifications Page 123

  • Download
  • Add to my manuals
  • Print
  • Page
    / 143
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 122
Beep Codes
Your computer might emit a series of beeps during start-up if the monitor cannot display errors or problems. This series of beeps, called a beep code, identifies
a problem. One possible beep code (code 1-3-1) consists of one beep, a burst of three beeps, and then one beep. This beep code tells you that the computer
encountered a memory problem.
If your computer beeps during start-up:
1. Write down the beep code on the Diagnostics Checklist.
2. Run the Dell Diagnostics to identify a more serious cause.
3. Contact Dell for technical assistance.
green
green
green
yellow
A possible USB failure has
occurred.
l Reinstall all USB devices, check cable connections, and then restart the computer.
yellow
yellow
yellow
green
No memory modules are
detected.
l Reinstall all memory modules and restart the computer.
l To eliminate the possibility of a faulty memory connector, remove all memory modules, reinstall one
memory module (if the computer supports a single module), and then restart the computer. If the
computer starts normally, move the memory module to a different connector and restart the
computer. Continue until you have identified a faulty connector or reinstalled all modules without
error.
yellow
green
yellow
green
Memory modules are
detected, but a memory
configuration or compatibility
error exists.
l Ensure that no special memory module/memory connector placement requirements exist (see
"Memory" for more information).
l Verify that the memory modules that you are installing are compatible with your computer.
l If the problem persists, contact Dell.
yellow
green
green
green
Another failure has
occurred.
l Ensure that the cables are properly connected to the system board from all installed hard drives.
l Check the computer message that appears on your monitor screen.
l If the problem persists, contact Dell.
green
green
green
green
The computer is in a normal
operating condition after
POST.
l None.
Code
Cause
1-1-2
Processor register failure
1-1-3
NVRAM
1-1-4
ROM BIOS checksum failure
1-2-1
Programmable interval timer failure
1-2-2
DMA initialization failure
1-2-3
DMA page register read/write failure
1-3-1 through 2-4-4
Memory not being properly identified or used
3-1-1
Slave DMA register failure
3-1-2
Master DMA register failure
3-1-3
Master interrupt mask register failure
3-1-4
Slave interrupt mask register failure
Page view 122
1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 142 143

Comments to this Manuals

No comments