Back to Contents Page
Memory
Dell™OptiPlex™170LUser'sGuide
Memory Installation Guidelines
Installing Memory
Removing Memory
Memory Installation Guidelines
For information on the type of memory supported by your computer, look under "Memory" in the "Specifications" section.
DDR Memory Overview
DDR memory modules should be installed in pairs of matched memory size, speed, and technology. If the DDR memory modules are not installed in matched
pairs, the computer will continue to operate, but with a slight reduction in performance.
l If you install a mixed pair of PC2700 (DDR 333-MHz) and PC3200 (DDR 400-MHz) memory, the modules function at the slowest speed installed.
l Be sure to install a single memory module in DIMM1, the connector closest to the processor, before you install modules in the other connectors.
l The actual speed of the SDRAM memory channel will depend on the speed of the processor's front side bus.
Installing Memory
1. Follow the procedures in "Before You Begin."
2. Press out the securing clip at each end of the memory module connector.
NOTICE: If you remove your original memory modules from the computer during a memory upgrade, keep them separate from any new modules that
you may have, even if you purchased the new modules from Dell. If possible, do not pair an original memory module with a new memory module.
Otherwise, your computer may not start properly.
Comments to this Manuals