Dell Precision Workstation 350 Technical Information download pdf (Page 15)

Back to Contents Page

AGP Card

DellPrecision™Workstation350ServiceManual



Removing an AGP Card

1. Some AGP cards require a power cable. If the card has a power cable attached to it, disconnect the cable from the card.

2. Remove the filler bracket by raising the hinged lever and sliding the bracket up.



3. Press the card lever toward the PCI connector.

4. Pull the card up and out of the card clip.



Installing an AGP/Card

1. To add or replace the card, press the card lever toward the PCI connector and gently press the card into the AGP connector until it clicks into place.

2. Release the card lever, ensuring that the tab fits into the notch on the front end of the card.

3. Secure the card by lowering the hinged lever on the back panel.

4. If you disconnected a power cable from the card in step1 of the previous procedure, reconnect the cable to the card.

5. Close the computer cover.

6. Connect the monitor cable to the card's video connector.



CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the System Information Guide.

hinged lever

filler bracket

notch

card clip

lever

AGP connector

tab

PCI connector

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Comments to this Manuals

No comments

Dell Precision Workstation 350 Technical Information Page 15

Comments to this Manuals

Related products and manuals for Networking Dell Precision Workstation 350