Dell Precision Workstation 350 Technical Information download pdf (Page 6)

Back to Contents Page

Chassis Intrusion Switch

DellPrecision™Workstation350ServiceManual



Removing the Chassis Intrusion Switch



1. Disconnect the chassis intrusion switch cable connector from the control panel on the front of the chassis.

Note the routing of the chassis intrusion cable as you remove it from the chassis. Chassis hooks may hold the cable in place inside the chassis.

2. Slide the chassis intrusion switch out of its slot and remove the switch and its attached cable from the chassis.

Replacing the Chassis Intrusion Switch

To replace the chassis intrusion switch, follow the "Chassis Intrusion Switch" procedures in reverse order.

Resetting the Chassis Intrusion Detector

1. Enter system setup by pressing <F2> during the computer's POST.



2. Under the System Security tab, reset the Chassis Intrusion option by pressing the left- or right-arrow key to select Reset. Change the setting to

Enabled, Enabled-Silent, or Disabled.



3. Press <Alt><b> to restart the computer and implement your changes.

Back to Contents Page



CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the System Information Guide.

NOTE: For instructions on using system setup, see the User's Guide.

NOTE: The default is Enabled-Silent.

NOTE: If a setup password has been assigned by someone else, contact the network administrator for information on resetting the chassis intrusion

detector.

1 2 3 4 5 6 7 8 9 10 11 ... 39 40

No comments

Dell Precision Workstation 350 Technical Information Page 6