Dell 2130 Color Laser Troubleshooting Guide Page 21
- Page / 204
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Printer Maintenance
The Printer Maintenance tab includes the System Settings, Paper Density, Registration Adjustment, Adjust Altitude, Reset Defaults, Non-Dell Toner,
Initialize PrintMeter, Tray Settings, TCP/IP Settings, and Network Settings pages.
System Settings
Purpose:
To Use these settings to configure the printer's power management, warning tones, time-out time, operator panel language setting, job log auto print,
position of the Print ID, setting of the dump print, setting of the additional memory, setting of the substitute sheet, mm/inch setting, and duplex print settings.
Values:
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Power Saver Timer
Mode 1*
1
1-30 Min.
Specifies the time before the printer enters the power saver timer mode 1(sleep mode) after it
finishes a job.
3 Min.*
Power Saver Timer
Mode 2*
1
5-60 Min.
Specifies the time before the printer enters the power saver timer mode 2 (deep sleep mode) after
it goes into the power saver timer mode 1.
10 Min*
Audio Tones
Control Panel Tone
Off*
Does not emit a tone when the operator panel input is correct.
On
Emits a tone when the operator panel input is correct.
Invalid Key Tone
Off*
Does not emit a tone when the operator panel input is incorrect.
On
Emits a tone when the operator panel input is incorrect.
Machine Ready Tone
Off*
Does not emit a tone when the printer becomes ready.
On
Emits a tone when the printer becomes ready.
Job Complete Tone
Off*
Does not emit a tone when a job is complete.
On
Emits a tone when a job is complete.
Fault Tone
Off*
Does not emit a tone when a job ends abnormally.
On
Emits a tone when a job ends abnormally.
Alert Tone
Off*
Does not emit a tone when a problem occurs.
On
Emits a tone when a problem occurs.
Out of Paper Alert
Tone
Off*
Does not emit a tone when the printer runs out of paper.
On
Emits a tone when the printer runs out of paper.
Low Toner Alert
Tone
Off*
Does not emit a tone when toner or some other consumable is low.
On
Emits a tone when toner or some other consumable is low.
Base Tone
Off*
Does not emit a tone when the operator panel display is returned to the default settings by
scrolling the loop menu.
On
Emits a tone when the operator panel display is returned to the default settings by scrolling the
loop menu.
Fault Time-Out
0
Disables the fault time-out.
3-300 sec
Specifies the amount of time the printer cancels for a job stops abnormally.
60 sec*
Time-Out
0
Disables the job time-out.
5-300 sec
Specifies the amount of time before the printer cancels for jobs that stop abnormally.
30 sec*
Panel Language
English*
Specifies the language to be used on the operator panel.
French
Italian
German
Spanish
Dutch
Danish
Norwegian
Swedish
Auto Log Print
Off*
Does not automatically output a log of completed jobs from the printer.
On
Outputs a log of completed jobs from the printer automatically.
Print ID
Off*
Does not print the user ID.
Top Left
Prints the user ID on the specified location.
Top Right
Bottom Left
Downloaded from ManualsPrinter.com Manuals
- Print Media Guidelines 2
- Recommended Paper 3
- Unacceptable Paper 3
- Selecting Paper 3
- Envelopes 4
- Labels 5
- Supported Paper Types 6
- Paper Type Specifications 6
- Loading Print Media 8
- Loading Letterhead 10
- Loading Envelopes 10
- Single Sheet Feeder 11
- Loading an Envelope 12
- Using the Duplex Function 13
- Using the Output Tray 13
- Printer Settings 15
- Resetting Defaults 17
- Printer Settings Report 19
- Reports 20
- TCP/IP Settings 20
- Printer Maintenance 21
- Paper Density 22
- Registration Adjustment 22
- Non-Dell Toner 23
- Initialize PrintMeter 24
- Diagnosis 25
- Chart Print 26
- Machine Check 26
- Paper Wrinkle Check Mode 26
- Environment Sensor Info 27
- Developer Stir Mode 27
- Refresh Mode 27
- Report/List 28
- Admin Menu 29
- Protocol 30
- IP Filter 30
- System Settings 31
- Audio Tones 32
- Fault Time-Out 32
- Time-Out 32
- Panel Language 32
- Print ID 33
- Print Text 33
- Banner Sheet 33
- Auto Log Print 33
- RAM Disk 34
- Odd Page 2Sided 34
- Substitute Tray 34
- Maintenance 35
- Adjust Fuser 36
- Auto Reg Adj 36
- Color Reg Adj 36
- Clear Storage 38
- Paper Tray 38
- Paper Size 38
- Orientation 38
- 2 Sided 39
- Symbol Set 40
- Font Size 40
- Font Pitch 40
- Form Line 40
- Quantity 41
- Image Enhance 41
- Hex Dump 41
- Draft Mode 41
- LineTermination 41
- Tray Settings 42
- Tray 1 43
- Tray 2 43
- Stored Print 44
- Setting Panel Lock 44
- Disabling Panel Lock 45
- Printer Status Window 46
- Status Monitor Console 46
- Software Update 46
- Printer Settings Utility 47
- Printing 48
- Printing a Report Page 49
- Printing a Font Sample List 50
- Stored Print 51
- Proof Print 51
- Secure Print 51
- Windows 2000 53
- Point and Print 54
- Peer-to-Peer 55
- Understanding Fonts 59
- Resident Fonts 60
- Symbol Sets 62
- Wingdings 63
- ITC ZapfDingbats MS 63
- Clearing Jams 68
- Troubleshooting Guide 76
- Print Quality Problems 77
- Random spots/blurred images 79
- The entire output is blank 80
- Pitched color dots 81
- Vertical blanks 82
- Ghosting 82
- Light fatigue 83
- Bead-Carry-Out (BCO) 83
- Jagged characters 84
- Banding 84
- Auger mark 85
- Creased/stained paper 85
- Abnormal Noise 86
- Jam/Alignment Problems 87
- Regi jam 88
- Exit Jam 88
- Option Problem 89
- Other Problems 89
- Contacting Service 89
- Personal Printer Setup 91
- Network Printer Setup 91
- Before Installation 93
- Start Remote Registry 94
- Disable Simple File Sharing 95
- Setup Security 96
- Resetting Defaults 97
- Printer Setup 99
- Maintaining Your Printer 100
- Storing Print Media 101
- Storing Consumables 101
- Replacing Toner Cartridges 101
- Installing the PHD Unit 104
- Replacing Retard Roller 106
- Determining Values 112
- Fast Scan 113
- Slow Scan 113
- Entering Values 114
- When Using the Tool Box 115
- Removing Options 116
- Removing a Duplexer 117
- Removing a Memory 118
- Printer Specifications 122
- Environment 123
- Cables 123
- Back to Contents Page 124
- Appendix 125
- Contacting Dell 126
- Front View 127
- Rear View 127
- Operator Panel 129
- Finding Information 131
- About Your Printer 133
- Connecting Your Printer 137
- Turn On the Printer 138
- Assign an IP Address 140
- Using the Reset Button 141
- For Internet Explorer 145
- 6.0, Internet Explorer 7.0 145
- For Firefox 2.0 or Later 146
- Page Display Format 147
- Details of the Menu Items 148
- Printer Status 149
- Printer Jobs 150
- Printer Settings 150
- USB Settings 153
- PCL Settings 153
- Printer Maintenance 154
- Auto Registration Adjustment 155
- Clean Developer 155
- Adjust Altitude 155
- Reset Defaults 155
- Print Server Settings 156
- NetWare Setup Page 158
- E-Mail Alert Setup Page 158
- NetWare 161
- E-Mail Alert 162
- SNMP v1/v2c 163
- SNMP v3 163
- Other Features 164
- Copy Printer Settings 165
- Print Volume 166
- Tray Settings 167
- Installing a Duplexer 170
- Installing a Memory 173
- For Windows Vista/Vista x64 175
- For Windows 2000 176
- Contents of Box 179
- For DHCP network: 184
- For Fixed IP network: 186
Related products and manuals for Laser/LED printers Dell 2130 Color Laser
Laser/LED printers Dell B1165nfw User's Guide
(303 pages)
(303 pages)
Laser/LED printers Dell 1110 User's Guide
(76 pages)
(76 pages)
Laser/LED printers Dell 2355dn User's Guide
(320 pages)
(320 pages)
© 2020, manymanuals.com. All rights reserved. | 0.256 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals