To initialize wireless network settings. After executing this function and rebooting the printer, all wireless network settings are reset to their default values.
TCP/IP
Purpose:
To configure TCP/IP settings. Any changes made become effective after the printer is turned off and then on.
Values:
Protocol
Purpose:
To enable or disable each protocol. Any changes made become effective after the printer is turned off and then on.
Values:
IP Filter
Purpose:
NOTE: This item is only displayed when an optional wireless printer adapter is installed.
Uses both IPv4 and IPv6 to set the IP address.
Uses IPv4 to set the IP address.
Uses IPv6 to set the IP address.
Automatically sets the IP address.
Uses BOOTP to set the IP address.
Uses RARP to set the IP address.
Uses DHCP to set the IP address.
Enables the IP address entered on the operator panel.
Sets the IP address allocated to the printer by using the keys on the operator panel.
Sets the gateway address.
*
1
Only displayed when an optional network protocol adapter is installed and IPsec is enabled.
Enables the Port9100 port.
Disables the Port9100 port.
Does not use IP for NetWare.
Enables the Email Alerts feature.
Disables the Email Alerts feature.
Enables an access to Dell Printer Configuration Web Tool embedded in the printer.
Disables an access to Dell Printer Configuration Web Tool embedded in the printer.
Disable the HTTP-SSL/TLS.
*
1
Only displayed when an optional network protocol adapter is installed.
*
2
Only displayed when an optional network protocol adapter is installed and which is authenticated by EWS.
Downloaded from ManualsPrinter.com Manuals
Comments to this Manuals