Uses both IPv4 and IPv6 to set the IP address.
Uses IPv4 to set the IP address.
Uses IPv6 to set the IP address.
Automatically sets the IP address.
Uses BOOTP to set the IP address.
Uses RARP to set the IP address.
Uses DHCP to set the IP address.
Enables the IP address entered on the operator panel.
Sets the IP address allocated to the printer by using the
keys on the operator panel.
Sets the gateway address.
*
1
Only displayed when an optional multi-protocol card is installed on the printer.
*
2
Only displayed when IPsec is enabled.
*
3
This mode is available only when firmware version 200706291103 or later and network (MPC) firmware
version 16.03 or later are installed. Since you cannot set IPsec in Windows Vista in this mode, use the Dell
Printer Configuration Web Tool. The Get Information from Printer function on the Options tab of
the printer driver is not available when using this mode.
Protocol
Purpose:
To enable or disable each item. The change becomes effective after the printer is turned off and then on
again.
Values:
Comments to this Manuals