on the network even when the protocol is not in use. This may slightly increase network traffic. To eliminate
unnecessary traffic, you can disable unused protocols.
Press until >SETUP appears, and then press .1.
Press until >Admin Menu appears, and then press .2.
Press until >Wired Net or >Wireless Net appears, and then press .3.
Press until >Protocol appears, and then press .4.
Press to select the desired settings, and then press .
Port9100
FTP
SNMP UDP
E-Mail Alert
EWS
5.
Configuring TCP/IP
Static Addressing: TCP/IP address is assigned manually by the system administrator.
Dynamic Addressing BOOTP/DHCP(default): TCP/IP address is assigned automatically by a DHCP or
BOOTP server on your network.
Static Addressing
To enter the TCP/IP address from your multifunction printer's operator panel, take the following steps:
Press until >SETUP appears, and then press .1.
Press until >Admin Menu appears, and then press .2.
Press until >Wired Net or >Wireless Net appears, and then press .3.
Press until >TCP/IP appears, and then press .4.
Press until >IP Address appears, and then press .5.
An IP address consists of 4 bytes.
Comments to this Manuals