protocols can be accomplished by using the supplied network program.
You can configure the basic network parameters through the multifunction printer's operator panel. Use the
printer operator panel to do the following:
Print a Network Configuration Page
Configure TCP/IP
Configuring Network Parameters on the Operator Panel
Printing a Network Configuration Page
The Network Configuration page shows how the network interface card on your multifunction printer is
configured. The default settings are suitable for most applications.
Press until >SETUP appears, and then press .1.
Press until >Admin Menu appears, and then press .2.
Press until >Admin Reports appears, and then press .3.
Press until >Server Address appears, and then press .4.
The Network Configuration page prints out.
Setting Network Protocols
When you first install the multifunction printer, all supported network protocols are enabled when you power
the multifunction printer on. If a network protocol is enabled, the multifunction printer may actively transmit
1.
Comments to this Manuals