IP Filter (IPv4)
Purpose:
To specify that data received from certain IP addresses through the wired network is blocked. You can set up
to five IP addresses. The change becomes effective after the printer is turned off and then on again.
Values:
No. n/Address (n is 1-5.)
Sets the IP address for Filter n.
Sets the mask for Filter n.
Disable the IP Filter feature for Filter n.
Accepts an access from specified IP address.
Rejects an access from specified IP address.
*
1
This item is only available for LPD or Port9100.
Initialize NVM
Purpose:
To initialize wired network data stored in NVM. After executing this function and rebooting the printer, all
wired network settings are reset to their default values.
Adobe Protocol
Purpose:
To specify PostScript communication protocol for each interface. You can configure the Adobe Protocol
settings for the wired network. The change becomes effective after the printer is turned off and then on
again.
Values:
Comments to this Manuals